When talking about the installation of a car radio, some of you may think it hard for you to install the new car radio by yourself. However, as a matter of fact, you can try to finish the car radio removal and installation even if you don’t have much expertise. To help you succeed in upgrading, you can find a correct installation guide to help you. The following is a 2006 2007 2008 2009 2010-2016 TOYOTA RUSH Second Generation car radio installation guide from Seicane. If you have the same or similar dashboard, you can refer to it carefully.
2006 2007 2008 2009 2010-2016 TOYOTA RUSH Second Generation Bluetooth Stereo after installation
Precautions for this installation:
1. Before you start up any work, park your car well and unplug the negative power cable to avoid any danger.
2. Please make sure that all fastened wires are isolated with electrical tape.
3. Please make sure the ignition is off to avoid short circuit.
4. For your convenience, here’s therecommended tools for removal and installation from Seicane, please check for more details:http://www.seicane.com/car-dvd-dismantling-device-srd-400
2006 2007 2008 2009 2010-2016 TOYOTA RUSH Second Generation car radio installation guide
1. Remove the original panel with a plastic knife, pry gently along the gap and pick up the panel, then remove it and then set it aside.
Remove the original panel with a plastic knife, pry gently along the gap and pick up the panel, then remove it and then set it aside
2. Remove screws that fixed the radio on the dashboard.
Remove screws that fixed the radio on the dashboard
3. Pull the factory radio out of the dash. Pull it with medium force, as the wires are connected to the radio.
Pull the factory radio out of the dash. Pull it with medium force, as the wires are connected to the radio
4. Unplug the connectors at the back of the factory radio.
Unplug the connectors at the back of the factory radio
5. Make antennas and cables connected step by step, and you should be very careful when you are doing this for it will affect whole procedure.
Make antennas and cables connected step by step, and you should be very careful when you are doing this for it will affect whole procedure
6. Put the new Seicane radio into your car, you should check whether your connections are correct, and you’d better have a tidy for the cables.
7. If everything is OK, firm screws into their original place.
If everything is OK, firm screws into their original place
8. Firm the panel on the new Seicane radio. Finally the new Seicane radio is installed and a comprehensive test should be conducted on the new radio.
Firm the panel on the new Seicane radio. Finally the new Seicane radio is installed and a comprehensive test should be conducted on the new radio
Now can you fully understand all the above installation steps for a 2006 2007 2008 2009 2010-2016 TOYOTA RUSH Second Generation car radio? If you cannot fully understand these steps, you can consult your dealer, communicate with someone experienced or turn to a professional for help. Besides, if you are still looking for a suitable car radio for a 2006 2007 2008 2009 2010-2016 TOYOTA RUSH Second Generation, you can check out the following link which is a remarkable 2006 2007 2008 2009 2010-2016 TOYOTA RUSH Second Generation car radio from Seicane..
Upgraded to the advanced Android 7.1.2 operation system, this car radio runs smoother and has a better performance than ever before.
Thanks to the high-accuracy 3D GPS navigation system, you can easily know your current location and navigate to any locations you would like to go to through turn-by-turn directions and voice prompts. And this unit’s dual zone function enables you to freely listen to your favorite music while navigating.
Besides, this unit also comes with additional entertainment features to relax both yourself and your passengers in car.
Wish you like this car radio. Good luck!
Recent Comments